Dr. Blip's PC-Doctor Forum

General Category => Ask Our Experts => Topic started by: mperrotta on January 05, 2011, 12:12:43 pm

Title: Error with Batch File
Post by: mperrotta on January 05, 2011, 12:12:43 pm

I am having an issue using the /tm switch with a script file.

pcdr /au:pcdrauto.ini /tm:1440

Whenever I try to use it I receive "Unknown command option"

I tried the following which was straight from the manual and still received the error.

pcdr /rt:cpu&* /tm:10

Any help with this would be appreciated.

Title: Re: Error with Batch File
Post by: fwilson on January 05, 2011, 01:58:25 pm

mperrotta,

I apologize, the /tm:xxx command line option is only available with the Factory version of our product.  Service center was released with the factory command line reference.

What I would suggest is using the /pc:xxxx option instead, which is included in the Service Center product.  /pc:xxxx is for pass count, the xxxx value can be from 1-9999.  It won't run for a set amount of time but will test the dickens out of components.

Sorry about the confusion, documentation is always a challenge, especially with something as complex as PC-Doctor.

-Fred

Title: Re: Error with Batch File
Post by: mperrotta on January 06, 2011, 05:16:53 am

Understood, thank you for the clarification.

Title: Re: Error with Batch File
Post by: fwilson on January 06, 2011, 09:37:10 am

mperrotta,

You are most welcome.

-Fred